REACTANCE:
In electrical and electronic systems,
reactance is the opposition of a circuit element to a
change in
current or
voltage, due to that element's
inductance or
capacitance. A built-up
electric field resists the change of voltage on the element, while a
magnetic field resists the change of current. The notion of reactance is similar to
electrical resistance, but it differs in several respects.
In
phasor analysis, reactance is used to compute amplitude and phase changes of
sinusoidal alternating current going through a circuit element. It is denoted by the symbol

. An ideal
resistor has zero reactance, whereas ideal
inductors and
capacitors
have zero resistance – that is, respond to current only by reactance.
The magnitude of the reactance of an inductor rises in proportion to a
rise in frequency, while the magnitude of the reactance of a capacitor
decreases in proportion to a rise in frequency (or increases in
proportion to wavelength). As frequency goes up, inductive reactance
goes up and capacitive reactance goes down
TYPES OF REACTANCE.
> CAPACTIVE REACTANCE
> INDUCTIVE REACTANCE
Capacitive reactance
Main article:
Capacitance
A capacitor consists of two
conductors separated by an
insulator, also known as a
dielectric.
Capacitive reactance is an opposition to the change of voltage across an element. Capacitive reactance

is
inversely proportional to the signal
frequency 
(or
angular frequency ω) and the
capacitance 
.
[1]
There are two choices in the literature for defining reactance for a
capacitor. One is to use a uniform notion of reactance as the imaginary
part of impedance, in which case the reactance of a capacitor is a
negative number:
[1][2][3]

Another choice is to define capacitive reactance as a positive number,
[4][5][6]

In this case however one needs to remember to add a negative sign for the impedance of a capacitor, i.e.

.
This article uses the former definition throughout.
At low frequencies a capacitor is an
open circuit so no
current flows in the dielectric.
A
DC voltage applied across a capacitor causes positive
charge to accumulate on one side and negative
charge to accumulate on the other side; the
electric field due to the accumulated charge is the source of the opposition to the current. When the
potential associated with the charge exactly balances the applied voltage, the current goes to zero.
Driven by an AC supply (ideal AC current source), a capacitor will
only accumulate a limited amount of charge before the potential
difference changes polarity and the charge is returned to the source.
The higher the frequency, the less charge will accumulate and the
smaller the opposition to the current.
Inductive reactance
Inductive reactance is a property exhibited by an inductor, and
inductive reactance exists based on the fact that an electric current
produces a magnetic field around it. In the context of an AC circuit
(although this concept applies any time current is changing), this
magnetic field is constantly changing as a result of current that
oscillates back and forth. It is this change in magnetic field that
induces another electric current to flow in the same wire, in a
direction such as to oppose the flow of the current originally
responsible for producing the magnetic field (known as Lenz’s Law).
Hence,
inductive reactance is an opposition to the change of current through an element.
For an ideal inductor in an AC circuit, the inhibitive effect on
change in current flow results in a delay, or a phase shift, of the
alternating current with respect to alternating voltage. Specifically,
an ideal inductor (with no resistance) will cause the current to lag the
voltage by a quarter cycle, or 90°.
In electric power systems, inductive reactance (and capacitive
reactance, however inductive reactance is more common) can limit the
power capacity of an AC transmission line, because power is not
completely transferred when voltage and current are out-of-phase
(detailed above). That is, current will flow for an out-of-phase system,
however real power at certain times will not be transferred, because
there will be points during which instantaneous current is positive
while instantaneous voltage is negative, or vice versa, implying
negative power transfer. Hence, real work is not performed when power
transfer is “negative”. However, current still flows even when a system
is out-of-phase, which causes transmission lines to heat up due to
current flow. Consequently, transmission lines can only heat up so much
(or else they would physically "sag" too much), so transmission line
operators have a “ceiling” on the amount of current that can flow
through a given line, and excessive inductive reactance can limit the
power capacity of a line.
Inductive reactance

is
proportional to the sinusoidal signal
frequency 
and the
inductance 
, which depends on the physical shape of the inductor.

The average current flowing through an
inductance 
in series with a
sinusoidal AC voltage source of RMS
amplitude 
and frequency

is equal to:

Because a
square wave has multiple amplitudes at sinusoidal
harmonics, the average current flowing through an
inductance 
in series with a square wave AC voltage source of RMS
amplitude 
and frequency

is equal to:

making it appear as if the inductive reactance to a square wave was about 19% smaller

than the reactance to the AC sine wave:
Any conductor of finite dimensions has inductance; the inductance is made larger by the multiple turns in an
electromagnetic coil.
Faraday's law of electromagnetic induction gives the counter-
emf 
(voltage opposing current) due to a rate-of-change of
magnetic flux density 
through a current loop.

For an inductor consisting of a coil with

loops this gives.

The counter-emf is the source of the opposition to current flow. A constant
direct current has a zero rate-of-change, and sees an inductor as a
short-circuit (it is typically made from a material with a low
resistivity). An
alternating current
has a time-averaged rate-of-change that is proportional to frequency,
this causes the increase in inductive reactance with frequency.
IMPEDANCE MEANING AND DISCUSSION
CAPACITANCE +REACTANCE+ INDUCTANCE+RESITANCE=IMPEDANCE
THE TOTAL OBSTACLES OFFERD BY ALL PASSIVE ELEMENT OF ELECTRICAL CIRCUIT IS KNOWN AS IMPEDANCE.
Both reactance

and
resistance 
are components of
impedance 
.

where:
is the impedance, measured in ohms;
is the resistance, measured in ohms. It is the real part of the impedance: 
is the reactance, measured in ohms. It is the imaginary part of the impedance: 
is the square root of minus one, usually represented by
in non-electrical formulas (
is used so as not to confuse the imaginary unit with current, commonly represented by
).
When both a capacitor and an inductor are placed in series in a
circuit, their contributions to the total circuit impedance are
opposite. Capacitive reactance

and inductive reactance

contribute to the total reactance

as follows.

where:
is the inductive reactance, measured in ohms;
is the capacitive reactance, measured in ohms;
is the angular frequency,
times the frequency in Hz.
Hence:
[3]
- if
, the total reactance is said to be inductive;
- if
, then the impedance is purely resistive;
- if
, the total reactance is said to be capacitive.
Note however that if

and

are assumed both positive by definition, then the intermediary formula changes to a difference:
[5]

but the ultimate value is the same.
Phase relationship
The phase of the voltage across a purely reactive device (a capacitor
with an infinite resistance or an inductor with a resistance of zero)
lags the current by

radians for a capacitive reactance and
leads the current by

radians for an inductive reactance. Without knowledge of both the
resistance and reactance the relationship between voltage and current
cannot be determined.
The origin of the different signs for capacitive and inductive reactance is the phase factor

in the impedance.

For a reactive component the sinusoidal voltage across the component is in quadrature (a

phase difference) with the sinusoidal current through the component.
The component alternately absorbs energy from the circuit and then
returns energy to the circuit, thus a pure reactance does not dissipate
power.